![]() ![]() On the KNX side, IntesisBox simulates a KNX device and acts as if it was a single device into the KNX system.The IntesisBox's KNX interface connects directly to the KNX bus and it is optoisolated from the rest of the internal electronics.Ĭonfiguration project is done through IntesisBox MAPS. IntesisBox Modbus Server - KNX datasheet v10 r12 eng TRADEMARKS: Todas las marcas y nombres utilizados en este documento se reconocen como marcas registradas de sus respectivos propietarios. IntesisBox is a Modbus RTU master and TCP C client device that allows to read / write points from other Modbus RTU slave devices and server devices that are. This useful feature allows actions on the same internal point from multiple KNX group addresses.IntesisBox acts as a master in the BACnet side allowing to read/write points of other BACnet/IP device(s) connected to a BACnet network and offering these point's values through its KNX interface. This gateway allows integrating a Samsung AC system inside a Modbus supervision/control/automation system through PLC, SCADA, and in general through any device or system with Modbus mastering (TCP or RTU) interface. To allow read requests, to allow write requests, to automatically send a write request to the KNX bus when its value changes, and to send a read request to the KNX bus when IntesisBox starts-up or after a bus reset.įor each point, one main group address and different listening group addresses can be defined. IntesisBox Modbus Server Samsung NASA AC is a communication gateway for Samsung NASA compatible outdoor units. Any point in IntesisBox can be configured individually for different functionality. ![]() ![]() The IntesisBox's KNX EIB interface connects directly to the EIB bus and is opto-isolated from the rest of the internal electronics. On the KNX side, IntesisBox simulates a KNX device and acts as if it was one more device into the KNX system. IntesisBox®Modbus Server - KNXis a communication gateway for KNX TP-1 (EIB) systems to Modbus slave (RTU and TCP). Extended version with capacity 3000 points and up to 254 slave devices. Points of Modbus TCP devices can be read/written from KNX. The Modbus interface of IntesisBox can be freely configured as RTU RS232, RTU RS485 or TCP. There are two different versions of IntesisBox® - KNX Modbus RTU master with different capacity every one of them: Basic version with capacity of 500 points and up to 254 slave devices. IntesisBox is a Modbus RTU Master and TCP Client device allowing to read/write. Every one of the Modbus points defined in IntesisBox is associated to a KNX group address, with this, all the Modbus slaves points are seen as KNX group addresses from the KNX system. Modbus interface of IntesisBox supports reading of other Modbus devices by continuous polling them. Any KNX integrator can integrate Modbus RTU Slaves or Modbus TCP Servers. IntesisBox is a Modbus TCP client device allowing to read/write points of other Modbus TPC Server device(s) connected to a Modbus TCP network, and offering these point's values through its KNX/EIB interface. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |